The Metwood 250 FR11 I-Joist Flange Reinforcer™

250 FR11 I-Joist Flange Reinforcers™ are designed to repair a notch cut from the top or bottom flange portion of a 11-7/8″ tall I-Joist with a 2.5″ flange.

The I-Joist Flange Reinforcers™ are engineered light gauge steel attachments for engineered I-Joists allowing larger openings in floor joists. The Metwood patented and engineered I-Joist Flange Reinforcer™ simplifies the routing and installation of utilities while repairing and restoring the strength of floor joists weakened by the placement of large holes or notch cut-outs.

Our Metwood Joist Reinforcers™ are shipped with the screws and drill bit needed for easy installation and are simply screwed to the side of the floor joist with no glue needed.

The 250 FR11 I-Joist Flange Reinforcers™ are designed to repair a notch cut from the top or bottom flange portion of an I-Joist that measure 2.5″. If using the 250 series on a flange larger or smaller than that of 2.5″, the web area or the flange area may need to be padded out so the 250 series Joist Flange Reinforcer™ fits tight against the joist.

If you have notch cuts in I-joists for plumbing or if you need to route plumbing through your floor joists, the Metwood 250 FR11 I-Joist Flange Reinforcer™ is the answer.

Metwood 250 FR11 I-Joist Flange Reinforcer™ is a Patented, Engineered, and Tested product!

Check out our product brochure and installation instructions below to see how easy installation is with the 250 FR11 I-Joist Flange Reinforcer by Metwood Building Solutions or you can check out our 250 FR214 I-Joist Repair Flange Reinforcer™ for notch repair on 14 inch I-joists, our 250 FR216 I-Joist Repair Flange Reinforcer™ for notch repair on 16 inch I-joists, or our 250 WR I-Joist Repair Web Reinforcer™ for openings in the web portion of an I-joist.